QP606 FOR INDUSTRY

  • Reduces power consumption.
  • Reduces downtime.
  • Reduces bearing temperature and wear.
  • Protect metal surfaces from contaminants.

Q Plus QP 606 is an oil-soluble, heat-stable compound of metal conditioner in a light petroleum carrier. It penetrates the metal surfaces, smoothing and sealing them without build-up or change in tolerances. It is completely compatible with any type of brand of petroleum oil or grease.

QP 606 reduces friction drag which makes industrial machinery start easier thus requiring less power to place it in operation. It also reduces time required for maintenance and lessens the chance of failure in mass-production work. It also increases the delivered power output of the machinery.

Microscopic irregularities of moving metal surfaces are smoothen and sealed with QP 606. Consequently, reducing bearing temperatures and wear making failures or seizures due to heat or overloading conditions reduced, thus, decreases repair costs and increases the time which machinery can be run between overhauls thereby minimizing non-profitable downtime.

QP 606 has a chemical attraction for moving metals. It penetrates the metal surfaces while smoothing them. This penetration of moving metal surfaces enables the metal conditioner to create a protective shield against extreme temperatures, boundary lubrications, acids and other corrosion causing contaminants regardless of the variation in the amount of contaminants present.

DIRECTIONS

PLEASE NOTE: Add QP 606 at each lubrication and oil change specified by manufacturer or at the intervals specified below if manufacturer recommends less frequent intervals. QP 606 is specially compounded to be used with industrial petroleum lubricants in the following proportions :

  • Stationary gasoline or diesel engines
    Add to oil in crankcase every 300 hours in the proportion of 2 % by volume to oil in unit.
  • Mechanical drive units (Industrial transmissions and gearboxes)
    Add to lubricant in unit of 6% every 2000 hours.
  • Hydraulic systems
    NOTE: NEVER ADD TO BRAKE FLUID
    Add to fluid in unit of 2% of volume in unit. Repeat treatment whenever fluid is changed or every 1000 hours.
  • Bearings
    Add to lubricant in the following proportions:

    • Oil-lubricated – 2% to volume to oil in unit
    • Grease-lubricated – 6% to volume to grease in unit
  • Air compressors
    Add to oil crankcase every 300 hours in the proportion of 2% to volume to oil in unit. Add to oil in upper oiler in the proportion of 2% to volume to oil in unit.
  • Refrigeration compressors
    NOTE: DO NOT USE WITH SULFER DIOXIDE REFRIGERANT.
    Add to oil in crankcase every 2500 hours in the proportion of 2% to volume to oil in unit.
  • Wire cables
    Add to lubricant in the following proportions:

    • Spray lubricated – 10% to volume to oil in unit
    • Dipped – 25% to volume to oil in unit
  • Air tools
    Add lubricant in the proportion of 1% to volume to oil in unit.

SPECIAL NOTE:
When adding QP 606 to bulk oil or grease, agitate thoroughly to insure even blending.