QP808 INTERNAL COMBUSTION ENGINES

  • Reduces gear noise and heat.
  • Reduces downtime.
  • Increase “delivered” horsepower.

Q Plus QP 808 is formulated to attract and penetrate metals under frictional conditions to smoothen and seal of metal without build-up or change in tolerances. It is compatible with any type of brand of motor oil or grease as it is both heat-stable and oil soluble.

PREVENT CARBON BUILD UP IN ENGINES AND INCREASES POWER OUTPUT
It shields the moving surfaces from carbon build-up, as it is too slick and slippery. The thin oil film enables engine parts to operate smoothly and perfectly at all speeds, reducing frictional power loss.

STOPS CORROSION EFFECTS OF COMBUSTION-FORMED ACIDS AND WATER
The surfaces are protected against the effects of combustion formed acids and moisture. Contaminants are dispersed into the oil and removed by the filter or when the oil is drained.

REDUCES GEARBOX TEMPERATURE
When QP 808 is added to the oils in gearboxes, it smoothes and seals the moving metal parts by reducing excessive frictional drags in gears. It works with top efficiency without the danger of overheating hereby lengthening the periods between overhauls and increasing payload efficiency.

INCREASED “DELIVERED” HORSEPOWER
A 10% gain in the pull–power is assured as frictional drag in the crankcase, gearbox and wheel bearings are reduced. With less drag to overcome, the engine transmits more actual power to the wheels.

QUIET AND SMOOTH GEAR OPERATION
Gears, which have been smoothed and sealed by QP 808, mesh together without scraping or binding. They operate smoothly upon each other and gear howl is eliminated.

ATTENTION: IT IS NOT A LUBRICANT AND CANNOT BE USED ALONE.

DIRECTIONS
Add QP 808 to regular specified lubricants in the following proportions.

CRANKCASE
Gasoline, diesel or steam engines 2% by volume to the oil in the crankcase. Add every 1,000 miles or every oil change.

MECHANICAL GEARBOXES AND DIFFERENTIALS
First use 12% by volume to grease in unit. Regular uses 6% by volume to grease in unit. Add every 5,000 miles or every flush or refill.

AUTOMATIC (Fluid) Transmissions
2% by volume to drive fluid.

CHASSIS FITTINGS
6% by volume to grease in gun or bulk container.

SPECIAL NOTE:
When adding QP 808 to bulk lubricant, agitate thoroughly to insure even blending.